First of all, I am not a tutorial, just a sharing of the settings of the network, welcome everyone to exchange network technology
Let me talk about my family's situation, the country house, three floors, each floor of about 100 square meters, 100M telecommunications broadband, fiber-optic entry point in the corner of the stairs between the first floor and the second floor, first on the general floor plan:
My home network has experienced several changes. In the beginning: The wireless router was in the fiber-optic entrance point, but due to too many corners, in the second bedroom, the corner of the living room network signal was poor.
Later: bought a VLAN switch, put the switch in the fiber home, wireless router in the living room, VLAN single-line reuse, but do not know if I bought the switch is too bad or how the matter, not stable, the switch model Like the BL-SG108M, there are times when the switch fails, VLAN does not work, wireless can be used, and other devices under the switch can not be used
Then is the present: think GEN8 on the hand only used to do black group Hui is a bit wasteful, try to see if you can do soft routing, beginning only soft routing LEDE, found that the function is very powerful, but QOS is very slag, full download A variety of packet loss and high latency, Baidu has no powerful flow control and lede function, found no, only to see the love flow control is very easy to use, so think of double-layer soft routing, set up under the lede Love fast, on the network topology:
In the IO8 IOL4 port casually connected to a wireless router, so that you can set up and manage GEN8 through a laptop and other wireless devices when there is no internal and external network, first open the hyper-v, as shown below
Create 4 new virtual switches
WAN mouth to pick up the cat, lan mouth switch,
Lede's network connection
Love fast network connection
The WAN port that loves fast is the virtual two dedicated network ports. The lan port of lede is dedicated port 1. The wan port of lede is connected to the optical cat, and the lan port that loves fast is connected to the switch, DSM, and host, so the network is basically set up. Now.
Then there is the flow control, the reason why I want to give love to fast virtual two mouths, is to flow control and SS diversion, because my family has a line for my tenant's home tenants use, I do not want his traffic to go SS, love Fast and lede single-line connection, then lede can not tell which way you need to go SS, which does not need to go SS. My home 100M telecommunications, upload 5M or so, equally divided to two ports, uplink 250, downlink 6250, and then do IP split settings
The tenant's traffic goes wan2, I go wan1 and wan2 myself and do the load balancing.
Then set the access control in the lede SS, wan1 port in the lede IP fixed allocation of 192.168.3.2, wan2 port fixed allocation: 192.168.3.3. 192.168.3.2 go SS, 192.168.3.3 do not go SS.
At the same time open the flow of love, two lines are added.
This completes the basic network setup. The rest is what the port maps.
In addition, the wireless network is now in the living room on the second floor put a wireless router set to AP mode, basically the whole building has wifi
At this point, sharing is completed
, what about the delay
Sunbathe the virtual machine again
Welcome everyone to pay homage
We are a factory who professional for Mono Solar Cells,Solar Cells Materials Used,Monocrystalline Solar Cell,Mono Crystalline Solar Cell. Most of our modules are customized as the clients requests. We have 400W to 550W half cells solar panel. Sure. custom is ok. Welcome to your inquiry and tell me your requests. Let's talk the details.
Mono Solar Cells,Solar Cells Materials Used,Monocrystalline Solar Cell,Mono Crystalline Solar Cell
Jiangxi Huayang New Energy Co.,Ltd , https://www.huayangenergy.com